Each PowerLinc light module possesses an address which can be found on its plug side. This address is specific to the module and provides added security preventing customers from using their own remote radio refrequency X10 devices to turn on and off your lights.
But before the PowerLinc light modules will work with Billiard Business Solutions the manager must enter the address of each PowerLinc light module in the program. From the Module Setup menu of the Light set up form, click on the PowerLinc setup menu. You should then see the following form for entering the PowerLinc address for each module.
You will start with table 1's light module and enter its address. You then add successive modules' addresses by clicking on the right arrow. Add as many modules as you would like--up to 60 modules. You may change these addresses whenever the need arises. But remember you must enter each modules specific adddress located on the plug side of the module: e.g. 15.AB.F9.
In the above example, the manager has entered the code '04.DE.21' in Table 1's light module ID . The Billiard Business Solutions program will use this specific code to turn the light on and off at table 1. He can also use this form to test the module to see if it actually turns the light on and off. Plug in the module after entering the correct code and plug in a light. And then just click on the Light on Test or Light off Test command buttons. Remember, the light must be in the on position before plugging it into the light module.